Machine Operating Tips - NCR Easy Point Series

• Replenishing the Receipt Printer Paper
• Replenishing Currency Cassettes
• Downloading the Electronic Journal

Procedure: Replenishing the Receipt Printer Paper

1. Unlock and open the facia (hood) of the terminal.
2. If there is any paper remaining on the paper roll core, tear between the roll and the printer. Press the black paper feed button until the remaining paper is fully ejected through the facia (hood) exit slot.
3. Lift up the remaining printer roll (or empty core). Remove the white plastic spindle from the paper core and retain the white plastic spindle.
4. Remove enough paper from the new paper roll so that no traces of glue or tape remain on the roll. Cut off the end of the supply roll to make a clean straight edge.
5. Insert the white plastic spindle through the core of the new paper roll. Make sure the white plastic spindle stops are fully pushed up against the paper roll core.
6. Lower the paper roll into the slots in the printer brackets so that the paper feeds forward over the top of the roll.
7. Insert the leading edge of the roll into the printer slot until the printer starts to feed the paper through automatically.
8. When paper stops feeding, press the black paper feed button once. The paper will feed through and cut automatically. If paper does not emerge, refer to "Clearing Receipt Printer Jams".
9. Push the facia (hood) back into the terminal and lock.
10. The Daily Menu is displayed on the screen. Select "General Menu".
11. Select "Initialize Receipt" to initialize the printer (remove blank receipt for exit tray).
12. Select "Daily Menu".
13. Press the Cancel key (the Select Menu will be displayed).
14. Press "Exit Supervisor".

Procedure: Replenishing Currency Cassettes

1. Unlock and open the lower door of the terminal. Open the security enclosure (safe).
2. Lift the catch on the right hand side of the currency cassette, and pull the cassette out of the terminal.
3. Pull the bottom of the green latch towards you.
4. Lift the latch up a small amount then pull the top of the latch towards you.
5. Raise the lid and remove the lid from the cassette base.
6. Lift the pusher arms and move the pusher to the opposite end of the cassette.
7. Latch the pusher by releasing the pusher arms.
8. Load bills into the cassette.
9. Lift the pusher arms and push the pusher and the bill stack to the back of the cassette, then release the pusher arms.
10. Insert the tabs on the cassette lid into the slots in the cassette base, and then lower the lid.
11. Lift the latch up and forward until it hooks onto the lid latch block.
12. Pull the latch down and push back until it clicks into the locked position.
13. Firmly push the full cassette into the terminal until the cassette latch clicks into place.
14. Close and lock the security enclosure.

Back to Top

Procedure: Downloading the Electronic Journal

1. Enter Supervisor mode by unlocking the terminal cabinet door, and pulling out the Facia (hood). The "Daily Menu" will be displayed on the screen.
2. Press the key to enter the "EJ Menu".
3. Place a diskette into the disk drive, and then press the key to "Initialize EJ".
4. Wait for green light on disk drive to turn off and the screen to display "Disk Copied OK".
5. Eject disk. Label with current date and terminal ID. Place inside security enclosure (safe).
6. Return Facia (hood) to original position. Close and lock terminal cabinet door.
7. Press the key to return to the "Daily Menu".
8. Press the "Cancel" key to display the "Select Menu".
9. Press the key to "Exit Supervisor".

Back to Top