Machine Operating Tips - Vend Towers

• Exact Change Indicator
• Coin Loading
• Coin Unloading

Quick Fact: Exact Change Indicator

• Red light shows ""No Change

Procedure: Coin Loading

1. Load coins into the coin slot at the top of the coin tower.
2. Press the white Reset button on the circuit board inside the coin tower after each $5.00 is added, and again when finished loading coins.

Procedure: Coin Unloading:

1. Press the Yes and No buttons, which are located on the circuit board inside the coin tower at the same time. The display will show "service", then "Meter A".
2. Press the Yes button. The display will show "Bypass A".
3. Press the Yes button. The display will show "Cash".
4. Press the Yes button. The display will show "Box".
5. Press the Yes button. The display will show "Bill".
6. Press the Yes button. The display will show "Tube" (amount of money in coin tubes).
7. Press the Yes button. The display will show "Done?".
8. Press the No button (or press the Yes button to go back to regular Vend mode). The display will show "Dsp .05".
9. Press the No button and hold it down (or press the Yes button to go to the .10). Nickels will unload out of the Coin Return.
10. When the nickel tube is empty, press the Yes button. The display will show "Dsp .10".
11. Press the No button and hold it down (or press the Yes button to go to .25). Dimes will unload out of the Coin Return.
12. When the dime tube is empty, press the Yes button. The display will show "Dsp .25".
13. Press the No button and hold it down (or press the Yes button to go to "Done?"). Quarters will unload out of the Coin Return.
14. When the quarter tube is empty, press the Yes button. The display will show "Done?".
15. Press the Yes button to go back to regular Vend mode.