Machine Operating Tips - TRM Model Number 9218

• Warm Up Time
• Adding Paper
• Replacing Toner Cartridge
• Changing Toner Disposal Tank

Quick Fact: Warm Up Time

• Approximately 80 seconds at room temperature of 68 degrees F.
• The machine should be left on during the day to avoid long warm-up times.
• There is no automatic shut-off feature.

Procedure: Adding Paper

1. Open the paper cassette cover and detach it.
2. Put the paper into the cassette so that the end of the paper contacts the paper end stopper, and the leading edge is on the cassette claws.

• NOTE: Do not allow paper height to exceed the paper stock line.

3. Press down the leading edge of the paper, so that is held under the cassette claws.
4. Replace the paper cassette cover, and the paper cassette.

Back to Top

Procedure: Replacing Toner Cartridge

WARNING: Before adding toner, carefully read the directions and safety information included with the toner cartridge. Keep toner away from children. Although toner is non-toxic, do not inhale it or allow it to enter your eyes. If toner comes in contact with eyes, consult your physician.

1. Hold the new toner cartridge vertically and shake it up and down nine or ten times to agitate the toner.
2. Pull the cover off the new toner cartridge.
   
   CAUTION: Do not peel off the plastic seal until the cartridge is set onto the developing unit.
   
   
3. Slide the toner cartridge cover over the opening at the bottom of the empty cartridge until it stops.
   
   NOTE: The toner cartridge cannot be removed unless the cover is set.
   
   
4. Hold the toner cartridge and pull it out with the cover set.
5. Slide the new toner cartridge onto the developing unit. Once set securely the toner cartridge cannot be pulled out.
   
   NOTE: Insert the toner cartridge with the seal facing towards the machine front, or it cannot be set properly.
   
   
6. Peel off the seal of the toner cartridge.

Procedure: Changing Toner Disposal Tank

1. Hold the top of the copier and unlock the release lever.
2. Open the main body.
3. Detach the toner disposal tank:
4. Attach the tank cover on the opening of the disposal tank, and give the disposal tank to the service personnel.
   
   NOTE: The used toner in the disposal tank cannot be reused.
   
   
5. Set a new toner disposal tank in the copier.
6. Close the main body and the front cover.

Back to Top